NAVTEX: bringing an SAR message to the watchkeeper's attention
RS and RKO rules: practical application
Receiving a new message in NAVTEX memory and alerting the bridge watch in time are two distinct outcomes. After replacing a panel or moving a receiver, document the whole chain: the system receives the message, presents the relevant information and alerts the watch to the search-and-rescue message at the vessel's control position. The SpectraTech catalogue includes the SAILOR 6390 kit with a 6004 panel and antenna, which may be suitable for this application.

Scope and edition of the rules
This example concerns an inland and seagoing vessel classed by the Russian Classification Society (RKO) for which the applicable documents require a NAVTEX receiver. It refers to Part VII of the classification and construction rules (PKPS), as amended by Order No. 29-p of 31 March 2026. The example does not establish a requirement for this kit on every vessel or route in Kazakhstan.
Clause 1.1.2 distinguishes vessels under design or construction from equipment already in service. Unless otherwise specified, equipment in service is subject to the rules under which it was built or manufactured. Specify the vessel class, operating area, mandatory communications equipment and applicable edition before selecting equipment. Clause 1.1.5 also calls for consideration of any additional Administration instructions.
The requirement applies at the vessel's control position
Under clause 2.6.5.9, reception of search-and-rescue messages must trigger an alarm at the position from which the vessel is normally navigated. The alarm is reset manually. Seeing a new message in the list does not establish where or how the watch receives the required alert.
Clause 4.8.1 allows a bridge-mounted printer or display for the MSI/SAR receiver. It does not require a printer for every system with a display. Where there is no printer, clause 2.6.5.11 also applies: the display must be at the vessel's control position. Check the proposed position against that condition, even if the display is already somewhere on the bridge.
For a quotation, specify separately where the message is read, where the watch can see and hear the alert, and where the alarm is acknowledged. If these locations differ, reflect that in the design and equipment list.
What the SAILOR 6390 provides
Manufacturer manual 98-137261-F describes a separate 6390 receiver operated through a 6004 panel or the ship's integrated navigation system (INS). The panel provides an audible alarm and displays warnings. In the documented scenario, a category D SAR message generates an audible alert and a pop-up, and the interface flags unread information. Check the hardware version, software version and applicable manual for the unit being supplied.
With an INS, message display and alerts depend on the agreed integration. A connection between the devices does not establish that the text is visible and the required alert is available at the intended workstation. Identify the receiving system and provide its documentation in the enquiry, along with any NMEA interface details.
NAVTEX receives information. That function does not allow the system to transmit its own distress alert. The vessel's specification determines which transmitting equipment and other mandatory items it needs.
Specify message display and alerts together
The 6390 manual describes the Display, Printer and INS filters separately. It also calls attention to keeping the selected stations consistent between the printer and display. This matters when information appears on one output but is expected on another. The article does not prescribe a single set of filter changes for all installations.
Include night operation in the workstation specification. Clause 4.2.10 provides for dimming the built-in lighting of radio equipment on the bridge. For the 6004, the manufacturer describes brightness adjustment and a night display mode. Set up the panel to support the watch and keep required alerts visible. A manual cover or a photograph of a lit screen does not establish this.
| Part of the system | Details to specify |
|---|---|
| Receiver | 6390 version, power supply, antenna and document revision |
| Message display | 6004 panel or specified INS and the position where messages are read |
| SAR alert | Vessel control position, alert devices and acknowledgement method |
| Verification | Agreed test scenario, acceptance criteria and record of results |
How to specify the kit and installation work
The catalogue listing includes the 6390, 6004 and an antenna. The quotation should specify the exact antenna model, connecting cables, any additional alert devices and the work required. If part of the installation will remain in use, provide its equipment markings and wiring diagram. A printer has separate requirements where the design calls for one. The term NAVTEX alone does not imply that a printer is included.
Under clause 4.8.2, MSI/SAR receivers are permanently connected to power supplies through fuses. The wiring and protection ratings depend on the design and the documentation for the particular equipment. When moving the panel, preserve the agreed operation of the complete installation and check more than whether an image appears on screen.
What the order should deliver
The acceptance programme should cover the required reception, display and alert functions at the relevant locations. Agree the method using the applicable rules and manuals, without generating a false distress alert. Record the results with the installed configuration and equipment list. The applicable documents and test programme determine when checks are repeated.
For a quotation for the SAILOR 6390 + 6004 + antenna please specify the vessel, class, operating area, vessel control position, existing panel or INS, and what must be replaced. Indicate whether a printer is required, which devices will remain in use, the quantity and the delivery city. We confirm the version, documents, condition, availability, full contents, price and lead time for the specific supply in writing.
Sources: Russian Classification Society (RKO), amendment to Part VII, Order No. 29-p; Cobham SATCOM, SAILOR 6390 User Manual 98-137261-F, Chapters 1–3 — manufacturer's manual hosted by a marine supplier.
More in this series
- Portable GMDSS: gloved operation and readiness for use
- New equipment near the magnetic compass: what to agree
- Echo-sounder trunk: access and water detection
- AIS: accounting for audible fault alarms
- NGR3000 antenna: information needed before choosing a location
- Echo-sounder cable: routing, shielding and deck connections
- EPIRB: float-free release and access to the container
- AIS-SART: the mounting arrangement is part of the package
- NTW-1000: checking the emergency-battery expiry date
- Echo-sounder transducer: conditions around the installation site
- Position source for GMDSS: include power supply in the brief
- AIS pilot plug: what to agree for the bridge
- DSC watchkeeping: the alarm must cover the whole bridge
- Speed log for a project: speed through the water or over the ground