FC-40: Confirm memory capacity for the specific version
Equipment: functions and package contents
The FC-40 antenna tuner stores matching settings so they can be recalled quickly. Before buying, confirm the capacity for the actual version on offer. The SpectraTech listing says 100 channels, while the manufacturer documents reviewed for this article give the FC-40 200 memories. The two figures cannot be combined or selected by preference without identifying the unit.
Vertex Standard / Yaesu FC-40 — SpectraTech listing

What figures the sources give
The FC-40 EAD77X101 instruction manual describes the model as an automatic tuner with 200 memories. The Impedance Matching Memories row in its Specifications table also gives 200 channels. These figures are from a particular manufacturer document. No stocked unit was tested for them.
Printed page 15 of the VX-1700 manual EC051H205 describes two external tuners. It gives 100 matching settings for the FC-30 and 200 for the FC-40. The numbers are adjacent in the text. The FC-30 figure still applies to the FC-30.
| Source | What the source states |
|---|---|
| FC-40 listing at SpectraTech | Memory: 100 channels |
| FC-40 instruction manual EAD77X101 | Impedance Matching Memories: 200 channels |
| VX-1700 manual EC051H205 | FC-30: 100 settings. FC-40: 200 settings. |
The discrepancy with the listing remains a question of the exact version and applicable documentation. The sources do not establish that the listing has a typo or that every unit with a similar enclosure has 200 memories. A quotation should state what is confirmed for the particular unit.
Tuner memories store antenna-matching settings
The stored parameters let the matching circuit return quickly to a suitable state. The FC-40 instructions describe recall when the same frequency range is selected again. This serves a different purpose from a transceiver’s list of channels, names and operating parameters.
A channel saved in the transceiver therefore does not establish that the corresponding tuner setting is stored and ready for fast recall. Discuss the two requirements separately when specifying the equipment. A radio channel list and confirmation of tuner operation establish different things about the station.
A memory entry also does not measure the current condition of the antenna or its connections. If behaviour changes after work on the installation, compare the specific conditions using the applicable test procedure. The number of memories alone cannot establish whether the whole system is serviceable.
Quick recall does not retain every setting indefinitely
The Antenna Tuning Procedures section of the VX-1700 manual gives a limit: as more widely spaced operating channels are used, settings are overwritten on a first-in, first-out basis. The memory has a finite capacity, so it does not retain every frequency ever used.
Retuning on a previously used frequency range therefore does not establish that the memory has failed. Consider which settings were stored later and whether the relevant entry was retained. The section does not list the contents of any individual tuner and is not a substitute for diagnosis.
Do not apply the button instructions in the separate FT-857D/FT-897D section to the VX-1700. The manufacturer refers readers to the manual for the transceiver in use. Determine the tuning, storage and verification procedure for the equipment pair being used.
What to confirm before ordering
For a quotation, obtain the exact marking, version details, transceiver in use and document establishing memory capacity. If the workflow depends on fast recall, include that result in the agreed acceptance check. Do not assume the unknown contents of a used tuner form a ready-to-use settings set for its next owner.
SpectraTech lists the FC-40 in its catalogue. The listing photograph shows the closed enclosure, mounting points and cable leads. The electronics and memory are out of view. Confirm condition, documentation, package contents, availability and cost in the quotation. For this article, the tuner was not opened, the memory was not reset and no transmission was made.
Sources: FC-40 EAD77X101, Specifications table; VX-1700 EC051H205, page 15, archive of the original manual; FC-40 listing at SpectraTech.